How to make smart glass?

1

How to make smart glass?
Step1. Wash and clean the glass.
Step2. Move the glass to the cleanroom for lamination.
Step3. Check the lower glass and clean possible stains.
Step4. Lay the pre-cut EVA interlayer on the lower glass.
Step5. Lay the PDLC film with busbars onto the EVA interlayer. During the process, the lower protective liner is removed. Then remove the upper protective liner. Note: Do not leave fingerprints or stains on the PDLC film.
Step6. Carefully adjust the position of the PDLC to align with the glass.
Step7. Lay out and align the upper layer of EVA interlayer.
Step8. Check and place the upper glass, carefully adjust the position of the glass to align with the lower glass.
Step9. Check the glass carefully to remove possible dirty spots and stains inside the glass.
Step10. Cut off the EVA interlayer to align with the glass.
Step11. Fix the busbars leads with high temperature tape, and wrap the glass edge with high temperature tape.
Step12. Move the glass to the next operating table.
Step13. Wrap the whole piece of glass in PET film.
Step14. Bond the PET film with silicone sealant strips to form a vacuum bag.
Step15. Set the vacuum port.
Step16. Pump the vacuum bag. Fold and firm the sides of the vacuum bag with high temperature tape.
Step17. During the pumping process, check whether the vacuum bag is leaking. After the pumping is complete, disconnect the pumping pipe.
Step18. Move the glass to the heating platform, connect the glass vacuum port to the vacuum system of the heating oven or autoclave, transfer the glass to the heating oven or autoclave, and heat the glass.
Step19. Heating. parameter settings.
Step20. After heating, remove the glass from the heating oven or autoclave. To pack and store.
If you want to get more informaion, please feel free to visit globalsmartglass.com.
https://globalsmartglass.com:Switch the smart glass,switch to a new world.